Tecfluid TM Series Uživatelský manuál stáhnout pdf (Strana 8)

The terminals are numbered 1 to 3 and the connection is as follows:

Nº 1: Ground

Nº 2: Coil

Nº 3: Coil

Before soldering the connections, unscrew the cable gland and feed it, together with the

electrical connection protector housing, over the cable.

The joint between the cable and the connector should always be soldered, and should be

tidy and without short circuits between terminals.

Peel the outside insulation to free the inner cables. It is recommended to tin the ends of

the wires to avoid loose ends.

Once the connections have been made, the housing should be mounted screwing it on

and then the cable gland should be tightened to avoid entry of any liquid or humidity.

Once assembled the half of the connector, the mounting in the base has only one position

defined by the keyway between the two parts.

Check that the rubber seal is in its position inside the connector base. If this is the case,

introduce the connector half in the base, positioning by the keyway, and screw on the nut

until the end of the thread is reached.

4 MAINTENANCE

The simple construction of the TM turbine results in a long life in normal working

conditions.

The life of the parts depends mainly on the abrasive characteristics of the product to be

measured and the maximum flow rate.

The combination of these two factors make it difficult to estimate the life of the

components in good working conditions.

If the maximum flow rates given for each DN in the following table are exceeded the life is

considerably reduced.

Flow ranges

Minimum flow

rate (m³/h)

Maximum flow

rate (m³/h)

Pressure drop (mm H

0) at

maximum flow rate

Maximum intermittent

flow rate (m³/h)

0,3 3 7500 5

0,6 6,8 7500 8

0,9 13,5 7000 16

1,9 30 5600 40

5 50 2800 60

9 90 2400 115

15 150 3100 180

100

28 280 4500 340

125

45 450 2400 560

150

65 650 2500 820

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Tecfluid TM Series Uživatelský manuál Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Tecfluid TM Series